(800) 317-4043 info@lightningprotectioncor.com   Request Quote     Contact Us       Site Map
  

 
Home 
About Us 
Certifications
Product
Categories
 
AC Power
Railroad
DC Power
Gas Tube Spark Gaps
RF Coaxial
Critical Circuit
Custom
Signal, Wire, Communications
Industries 
Choosing a
Surge Protector
 


Search Catalog :
GO
Use a (*) to broaden your search results
Search Catalog
      GO   
 All Categories    AC POWER, LIGHT DUTY, MULTI-VOLTAGE, SECONDARY LIGHTNING AND SURGE PROTECTIVE DEVICES
All Categories > AC Power > AC POWER, LIGHT DUTY, MULTI-VOLTAGE, SECONDARY LIGHTNING AND SURGE PROTECTIVE DEVICES > Model LPC 11765U-13E  

Model LPC 11765U-13E


    border="0" Printable Page  
    Email Email This Page  
    Save To Favorites Save To Favorites
  

The LPC 11765U-13E and -1E models provide light duty protection on any voltage system up to and including 480 VRMS, single and three phase. The two models substitute for at least 15 models of individual voltage ratings, eliminating the need for many separate SPD’s in inventory.

The SPD’s mount through a ¾” knockout or use an “L” shaped bracket. The enclosure is weatherproof and may be installed in fused panels, inside equipment cabinets, or on the equipment itself.

Protection is provided in all modes, i.e. each line to neutral, each line to ground, neutral to ground, and line to line. Response is less than 5 nanoseconds and only overvoltage transients are clamped. These SPD’s do not pass follow current, and stop conduction instantaneously once the voltage returns to normal. These SPD’s are not intended for the service entrance but for use deeper within the facility where surges are expected to be less severe.

Each model consists of 5 wires, each 6” long, for connection across the system wiring: for the hot wires, 3 black wires; for the neutral, 1 white wire; for earth ground, 1 green wire. The metal enclosure has provision for the safety wire (supplied by the customer). The 5 wires protrude through a threaded ¾” nipple located in the center of the 2¾” X 4½” face.

These SPD’s are not repairable. A defective SPD fails short circuit, in which case the line/branch fuses or breakers operate. A prolonged short circuit may open, and in the process cause rupture of the SPD elements.






 Specifications   Connections   Attributes   

Type

50/60 Hz, single/three phase, voltage to 240 VRMS, 20-45 KA surge current

For

120/240V -- 3W+G, 1 phase
120V -- 2W+G, 1 phase

208Y/120V -- 4W+G, 3 phase wye

240/120V -- 4W+G, 3 phase high leg delta

240V -- 2W+G, 1 phase

240V -- 3W+G, 3 phase delta

Response

Less than 5 nanoseconds

Protection

All modes

Applicable Standards

ANSI/IEEE Standards: All C62 that apply
UL Listed Std: 1449

Category

A, B, and C for light duty

Maximum Surge Current

20KA to 45KA, 8/20 µs per phase

Energy

3800 joules total


 DOWNLOADS 

Choosing an Arrester
(PDF, 2521KB)



Manufacturer - Developer - Designer
Manufacturer of the highest quality lightning and surge protective devices (SPD) since 1974.
Lightning Protection Corporation specializes in devices for industrial, commercial, government and worldwide applications!

   

Lightning Protection Corp. • Mailing: P.O. Box 6086, Santa Barbara, CA 93160  Plant: 5750 Thornwood Dr., Goleta, CA 93117 
(800) 317-4043 • ph: (805) 967-4577 • fax: (805) 967-4320 • info@lightningprotectioncor.com